NX100 Basic Programming
Course Details
Dates:
Jun 10, Jun 24, July 15, July 29, Aug 19, Sept 9, Sept 23
Length:
This course runs 4.0 days (26 hours), Mon-Thurs 8:30am - 4:30pm.
Price:
$1500
If you require assistance,
please call 937-847-3307.
This course is an introduction to programming the NX100 controller. No prior knowledge of robot programming or the NX100 controller is required.
Primary topics include:
- Robot Safety
- System power up/down
- Coordinate systems
- Arithmetic and I/O instructions
- Path editing
- Position levels
- Speed Correction
- Job functions
- Tool Control Point (TCP)
Course Overview
This course consists of classroom lectures, demonstrations, discussions and hands-on practice exercises. Covered topics are related to real-world examples and applications. To create an interactive and enhanced learning environment, class size is limited to 12. To perform the hands-on practice exercises, students are typically assigned 2 to a pendant at MTEC and no more than 3 to a pendant On-Site.
Course Materials
Students receive a copy of the NX100 Basic Programming Training Manual which details commands and programming technique for the Motoman controller. Additional handouts relate to specific topics covered in the class. Students are urged to take notes, participate in discussions, and to bring up specific programming issues.
Prerequisite
NONE
Notes
Training class schedules are subject to be changed without notice, based on training demands. All Training classes are held in the Miamisburg, OH Training Facility unless other prior arrangements have been confirmed.
