NX100 Basic Programming with Servo Motor Spot Gun
Call for class availability
This course runs 4.5 days, Mon-Thurs 8:30-4:30 and Friday 8:30 - 11:30 (29 hours)
If you require assistance,
please call 937-847-3307.
This course is an introduction to programming the NX100 controller. The course pertains to programming of a servo motor spot welding gun attached to the robot. No prior knowledge of robot programming or the NX100 controller is required.
Primary topics include:
- Working safely in and around the robot cell
- Powering up/down
- Jogging the robot using all coordinate systems
- Jogging the servo motor spot welding gun
- Checking specified point
- Path Creation for Single Group Jobs
- Path Creation for Multiple Group Jobs
- Modifying points, motion type and speed
- Recovering from alarms and errors
- Cutting and pasting instructions
- Programming I/O and control instructions
- Conditional "IF" Statement
- Programming spot welding instructions
This course consists of classroom lectures, demonstrations, discussions and hands-on practice exercises. Covered topics are related to real-world examples and applications. To create an interactive and enhanced learning environment, class size is limited to 3. To perform the hands-on practice exercises, students are typically assigned 2 to a pendant at MTEC and no more than 3 to a pendant On-Site.
Students receive a course outline, objectives, and a manual, which details specific topics covered in the class. Students are urged to take notes, participate in discussions, and inquire about specific operating issues.