NX100 Paint Maintenance
Call for class availability
This course runs 3.5 days (22 hours). Tues-Thurs 8:30-4:30 and Fri 8:30-11:30
If you require assistance,
please call 937-847-3307.
The NX100 Paint Maintenance Module is a preventative maintenance/troubleshooting course for the NX100 controller and EPX series industrial robots. Individuals responsible for maintenance/repair, preventive maintenance, troubleshooting, and diagnosis should attend this class.
Primary topics include:
- Intrinsically safe pendant
- NX100 controller hardware architecture
- Circuit board replacement
- Elementary diagrams
- I/O connections
- Power distribution
- Basic servo theory
- Servopack replacement procedures
- Motor replacement
- Preventive maintenance schedule
- Robot calibration procedures
Classroom lectures on maintenance procedures are reinforced with demonstrations. Material covered in the lectures is enhanced with actual hands-on maintenance and troubleshooting performed by students in Motomanís 5,200-sq.ft. training facility located in Greensburg, IN. Students perform lab exercises which reinforce topics covered in class lectures. Class size is kept small, typically 12 or fewer, to promote the high level of hands-on learning required. Students work closely with Motoman instructors to grasp the concepts of robot/controller maintenance. This course includes an optional one-day overview of basic robot programming for the selected controller to facilitate maintenance and diagnostics procedures. Those who have completed formal Basic Programming are not required to attend this part of the course.
Students receive a copy of the NX100 Paint Maintenance Module manual which details Preventative maintenance, troubleshooting, and repairing systems. Additional handouts relate to specific topics covered in the class. Students are urged to take notes, participate in discussions, and to bring up specific topics related to system maintenance.
In order to attend the 3.5 day NX Maintenance class, attendees must have attended the NX Basic Programming class. Otherwise, attendees must attend the 4.5 day NX Maintenance w/ Programming Overview.
Training class will be conducted at the Training Facility located in Greensburg, IN.