DX100 Basic Programming
May 23 (FULL), June 6 (5 - Seats Left), June 20 (3 - Seats Left), July 11, July 25, Aug 1, Aug 8, Aug 29, Sept 12
This course runs 4.0 days (26 hours), Mon-Thurs 8:30am - 4:30pm.
If you require assistance,
please call 937-847-3307.
This course is an introduction to programming the DX100 controller. No prior knowledge of robot programming or the DX100 controller is required.
Primary topics include:
- Robot Safety
- System power up/down
- Coordinate systems
- Motion type path programming
- Control, Arithmetic and I/O instructions
- Job editing
- Positioning accuracy tags
- Speed adjustment
- Job functions
- Tool Control Point (TCP)
This course consists of classroom lectures, demonstrations, discussions and hands-on practice exercises. Covered topics are related to real-world examples and applications. To create an interactive and enhanced learning environment, class size is limited to 12. To perform the hands-on practice exercises, students are typically assigned 2 to a pendant at MTEC and no more than 3 to a pendant On-Site.
Students receive a copy of the DX100 Basic Programming Training Manual which details instructions and programming technique for the Motoman controller. Additional handouts relate to specific topics covered in the class. Students are urged to take notes, participate in discussions, and to bring up specific programming issues.
Training class schedules are subject to be changed without notice, based on training demands. All Training classes are held in the Miamisburg, OH Training Facility unless other prior arrangements have been confirmed.