NX100 Basic Programming - (HACC) -
HACC - Chambersburg Technology Center
Call for class availability
This course runs 4.0 days (26 hours), Mon-Thurs 8:00am - 4:00pm.
If you require assistance,
please call 937-847-3307.
This course is an introduction to programming the NX100 controller. No prior knowledge of robot programming or the NX100 controller is required.
Primary topics include:
- Robot Safety
- System power up/down
- Coordinate systems
- Arithmetic and I/O instructions
- Path editing
- Position levels
- Speed Correction
- Job functions
- Tool Control Point (TCP)
This course consists of classroom lectures, demonstrations, discussions and hands-on practice exercises. Covered topics are related to real-world examples and applications. To create an interactive and enhanced learning environment, class size is limited to 8. To perform the hands-on practice exercises, students are typically assigned 2 to a pendant at HACC Technology Center and no more than 3 to a pendant On-Site.
Students receive a copy of the NX100 Basic Programming Training Manual which details commands and programming technique for the Motoman controller. Additional handouts relate to specific topics covered in the class. Students are urged to take notes, participate in discussions, and to bring up specific programming issues.
Training class schedules are subject to be changed without notice, based on training demands. Training is held at the HACC - Chambersburg Technology Technology Center located at 3055 Black Gap Road Chambersburg, PA 17202 For more information, please contact: (717) 221-1337 or email: firstname.lastname@example.org