Academy / Training / NX100 MAINTENANCE - Universal Pendant

for Toyota associates only 

Who Should Attend

 This is a course for Toyota associates only on how to do maintenance on the NX100 Toyota spec controller

Course Overview

This course covers electrical and mechanical components of NX100 robots with Toyota spec controller.  Students will have a programming review, removal and troubleshooting of controller components as well as motor removal, calibration and general PM list

Course Materials

Students will receive a copy of the NX100 MAINTENANCE - UNIVERSAL PENDANT manual.


- programming review - parameters - maintenance mode - electrical components and troubleshooting - mechanical components - motor removal - overview of greasing - overview of PM checklist


This course is 4 days in length, with a maximum of 4 students

Course Details - LAST UPDATED - 08/08/2019


2019 Dates: call for class availability


This course runs 4 days, 8am to 3:15pm.


$1350 CAN

If you require assistance, 
please call 905-813-5940.

Register for this Course

PLEASE NOTE: We are upgrading our Learning Management System to facilitate enrollment and enable monitoring of each student's enrolled classes, scores and certificates.

Effective immediately, each student must provide their own unique email address when registering for a class.
(You may register up to six students at a time)

Primary Contact Information

Preferred Payment Method
*Do not make travel/hotel arrangements until your class has been confirmed by the Training Coordinator.
*By submitting this registration form, you agree to Yaskawa Academy's Rescheduling and Cancellation Policies
This website stores cookies on your computer to provide you with more personalized services on this website and through other media.